ESC connections

VRBRAIN 5.x

Connecting the ESCS and optional outputs (gimbal control)

The ESCS should be connected without the 5V, (red cable) unless you plan to power the board using one of them. If you plan to use an ESC to power the board please be sure you have:

  • Only 1 ESC powering
  • You use one of the 8 outputs or 1 of the first 4 inputs.

The order ot the outputs is shown in below figure

ESC-Motor_connections_1
If using PPMSUM or SBUS you can use up to 12 channels.

The channels 9 to 12 are on the input rail on the first 4 channels as shown in figure:

 

ESC-Motor_connections_2

 

VRBRAIN 4.x

Connect ESC to pin 1 – 8 according to  the pin out

esc1 esc2 esc3