Dear all, VirtualRobotix is proud to announce the release of the 3.2 APM:Copter firmware for all VRX boards. VRBRAIN 5 and VRuBRAIN will be able to upload the firmware directly from mission planner using the “Initial Setup–>install firmware” menu. Just…

Dear all, in the VirtualRobotix.it e-shop you will find an expansion board for your 4.5 board. This will allow you to install 3.2 firmware with NuttX RTOSand enjoy Full logs on SD card, terrain following any many other upcoming features.…

Dear all, it’s been a while since last update, but things were going on, so we are finally proud to announce the new 3.2 firmware for all VRBRAIN 4.x users. https://vrbrain.wordpress.com/download/version-3-2/   Last week, APM developers finally released the 3.2…

In the firmware download section, I have pushed a new firmware update to allow the use of an external compass on the VRBRAIN 4.0 or 4.5 The instructions on how to connect an external compass can be found here: Using an…

Update in 3.1.13-final Update to official APM:Copter release 3.1 final Added Radio failsafe on power loss. This enables to set up failsafe if the receiver looses power or brakes in air. Please upgrade to this release following this link. This…

Update in 3.1.12-rc7 Reworked analog driver for better performance Reworked I2C driver to allow External Mag. External Mag can be connected to output 7 & 8 with appropriate firmware (VRBRAIN_xxx_EXT_MAG) still not released. Update to SPI driver to allow External…

Update in 3.1.11 SPI BUS speed for MPU6000 increased to 8MHz ENHANCEMENT of MPU6000 enabled by default (MPU6000 @ 1KHz and gyro full scale @ 1000dps) Update to latest 3.1rc5 of arducopter code Corrected bug in Dataflash log download Yellow…

This is an important release because it fixes random freezes of boards due to interrupt priorities. Please upgrade to this release following this link. Also a new Enhanced version has been published, this has a increased MPU6000 driver. The Gyro…

A new group has been created to help us support you on any question regarding developing, using and configuring your VRBRAIN. This is the address of the new group. You are more than welcome to join. It is a mailing…

Today the 3.1.3-alpha was released in the Firmware 3.0 download page. This release adds New 1KHz sensor update for the MPU6000 (gyro and accels run 5 times faster). This enables us to have 10 samples averaged for every main stabilization…